Indesit washing machine gives error F17 on the display? This means there is no voltage on the sunroof lock device.
The model with electromechanical control shows a fault code by flashing the “Spin” - “Delay for washing” indicators, the “Spin” - “Extra rinse” lamps are on.
What the error means - symptoms of a problem
The reason for the appearance of the error code F 17 may be a loose hatch. At the same time, the “Lock” indicator flashes, and washing does not start.
Also a sign of failure is that you are installing the program, but the machine does not work. What to do? Pay attention to other signals:
- After de-energizing the washing machine, Indesit the door will not unlock.
- You want to turn on the wash, but the lock does not fix the hatch, it gives an error F17.
The sunroof locking device (UBL) is responsible for the safe operation of the Indesit washing machine. Until the lid locks, water intake will not start. How to fix it and fix the error, we will tell further.
Check and repair
Before checking the lock for serviceability, you need to understand the principle of the lock.
As shown in the picture: after the control unit gives a signal to lock the door, the thermocouple heats up with the bimetal plate. When heated, the plate lengthens, presses on the lock - the lock is locked. As long as there is electricity, the lid is securely closed.
If the UBL functions normally, then the plate will cool in the absence of voltage. If the lock or triac of the control board breaks down, electricity flows continuously, so the door will be locked.
So, you can check the locking device using a power source. Another way is to use a multimeter. What does this mean?
- Connect the tester to the lock.
- Turn on any program and monitor the voltage.
- No power - check the contacts of the control unit with UBL.
How to replace the blocker yourself
It is possible that in order to remove the F17 error in Indesit СМА and solve the problem, it will be necessary to replace the UBL system. If the sunroof is open, do the following:
- Remove the rubber cuff that is responsible for sealing.
- Loosen the screws as shown in the photo.
- Take out the lock. It is located between the tank and the front wall.
- Disconnect the wires.
- Install the new latch in the reverse order.
But what if the door is locked? No panic:
- Remove the top panel of the Indesit washing machine.
- Tilt the machine back.
- Slide the lock lock by hand, feeling it between the wall and the tank.
- Open the cover and follow the instructions above.