The electronic control system has greatly facilitated the use of technology. The set temperature and modes are displayed on the display in the same way as the errors of the Electrolux refrigerator. Any problem is displayed on the display as a code, the meaning of which can be found in the instructions. Having learned the decryption, you will quickly find out the cause of the breakdown and ways to resolve it.
Electrolux error codes: table
A malfunction code may appear on the display accidentally due to a system malfunction. To avoid looking for reasons in vain, restart the technique. Unplug the plug and plug it in after only 15 minutes. If the characters are still displayed on the screen, it’s time to start decoding.
Error code | What does it mean | How to fix it yourself |
F1, F2 | The thermostat does not work. | Diagnose the part. Inspect the wiring: the contacts may have come off. Replace defective items. |
F3, F4 or F5 | NTC temperature sensor defective. | Tighten the contacts from the sensor to the control module. Replace sensor if broken. |
“-” on the display blinks | The temperature in the refrigerator is below 0 degrees. | There are problems with the evaporator. Probably, the sensor gives wrong readings, therefore the compressor does not stop cooling. For an accurate diagnosis, it is better to consult a specialist. |
The value “-” is constantly on. | Temperature above the indicated norm: more than 9 degrees. | Follow the same steps as for the previous problem. And:
|
Indicator b lights up | The evaporator sensor has failed or a freon gas leak has occurred. | Your actions:
|
LED with | Temperature sensor malfunction. | Repair, installation of a new element. |
Light bulb d | Thermistor elements have failed. | Installation of serviceable parts. |
Indicator o (as half a digit 8) | The freezer evaporator sensor does not work. | Diagnostics and replacement. |
Also, users of "Electrolux" refrigerators are faced with such problems:
- Noise during work.
- Condensation, accumulation of water under the drawers.
- The growths of ice and snow on the walls.
- Hot walls during operation.
- Damage to electrical components.
Do not allow the drainage hole to clog, do not keep the camera door open for a long time - then you will avoid many breakages.